Sony SAL16105 Service Manual page 32

HELP04-05
1. Install the focus stopper in the concave part of the focus ring and install the focus ring to the outer barrel.
Note:
When Install the focus ring, the part A is adjusted to the screw hole on the outer barrel and engage three projections of the
outer barrel with the groove of the focus ring by turning the focus ring in the arrow direction.
Focus Ring
Focus Stopper
Outer Barrel
Projections
2. Adjust the screw holes of the focus stopper can be seen through the long holes of the outer barrel and tighten two screws temporarily.
3. Turn the focus ring in the near position in the arrow direction.
Note:
Be sure to position the focus scale plate as shown in the picture.
4. While pushing focus stopper to left side tighten two screws temporarily.
Note:
Tighten lightly to the end and loosen 1/4 turn.
Note:
Refer to "Focus-shift Adjustment" for tightening up.
Focus Stopper
SAL16105 (DT 3.5-5.6/16-105) (DT 16-105mm F3.5-5.6)
Groove
Screw Hole
Part A
Long Holes of
Outer Barrel
Focus Stopper
Focus Ring
Part A
Outer Barrel
Projection
Screw Hole
Screw Holes of Focus Stopper
Set the focus to near position.
Projections
Focus Ring
Focus Scale Plate
HELP