Husky Altanium Neo2 User Manual page 38

Zone Alarm Window
Zone Sensor Input
Zone Name
Zone ON / OFF
Zone Setpoint Limits
Standby Setpoints
Boost Setpoints
Zone Regulation
Zone Slave
Zone Output
Priority Control Mode
Automatic Manual
Control
Zone Earth Leakage
Zone Power Limit
Zone Control
Zone PID
Mold Setup File Load
Mold Setup File Copy
Mold Setup File Default
Mold Setup
Import/Export
Temperature Units
28
v 1.4 — September 2015
Feature
Enables the operator to adjust the value for the ALARM condition.
Enables the operator to reassign Thermocouple Inputs.
Enables the operator to change the name of the zone.
Enables the operator to turn a zone ON or OFF.
Enables the operator to make changes to the minimum and maximum
setpoint limits. These limits are used to prevent a setpoint from being set
too high or too low depending on the requirement of the process.
Enables the operator to adjust the Standby setpoints in the System
screen.
Enables the operator to adjust the Boost setpoints in the System screen.
Enables the operator to adjust the zone regulation mode between AUTO
and MANUAL modes.
Enables the operator to manually select a zone to follow the power
output control of a different zone should the thermocouple fail.
Enables the operator to specify which power output control method to
use: Zero-Cross (Z/C) or Phase Angle (P/A).
Enables the operator to select the zone shutdown sequence between
ZONE and SYSTEM in an abort condition. If ZONE is selected ONLY the
zone will turn OFF, but if SYSTEM is selected ALL zones will turn OFF.
Enables the operator to enable the zone to continue running when the
thermocouple fails. The zone is supplied with an averaged power output
percentage in Manual Control Mode, based on the history of that same
zone.
Enables the operator to turn the earth leakage check On or Off.
Enables the operator to assign a power limit value to an individual zone
per mold setup. Power Limiting is defined in percentage (0%-100%) and
is used to prevent the controller from delivering full power to a heater.
Enables the operator to change between ART or PID as the control
method.
Enables the operator to adjust the P-I-D parameters in the ART/PID
screen.
Enables the operator to load Mold Setups from the Molds screen.
Enables the operator to copy a stored mold setup to a different location.
Enables the operator to delete the contents of a stored mold setup and
return all values to Husky's default.
Enables an operator to import or export a mold setup using a USB disk.
Enables the operator to toggle the displayed temperature units
between °F and °C.
Description
Security Item Descriptions
Altanium Neo2