Table of Contents
Advertisement
9.1.2 Software Release Number
Located in the center of the screen is the Neo2 Software Release Number, Build Number and
the USB Controller version. In the event the operator needs to contact Husky for service, the
technician may ask for these numbers. This is not a button and touching it will do nothing.
9.1.3 System KWH
This field displays a running kilowatt hours total for the system. This is informational only.
9.1.4 Basic And Advanced Display Modes
As described in
interface modes, Basic and Advanced. Basic and Advanced modes can be modified in the
Customize screen to display only those zone parameters that are desired.
Basic mode allows the operator to adjust the following parameters; Setpoint, Zone On/Off,
Regulation, Standby Setpoint, and Boost Setpoint.
Advanced mode allows the operator to adjust the Basic parameters plus; Alarm, Abort, Slave,
Sensor, Output Control, AMC, PCM, PID/ART, P, I, D, Re-ART, Earth Leakage, Name, Power
Limit, Min/Max Limits, Remote Standby and Remote Boost if configured.
All Neo2 systems are shipped from the factory in Basic mode.
9.1.5 Setting the Units (°F or °C)
Neo2 allows the temperature to be displayed in either Fahrenheit or Celsius for all zones. The
default setting is Fahrenheit (°F).
To change the units:
1.
2.
9.1.6 Changing the Time and Date
The date and time can be changed on the system. The system can display the date and time
in the following formats.
•
•
62
v 1.4 — September 2015
Chapter 4–Neo2 Operator
On the Home screen, touch SYSTEM SETUP.
Touch °F / °C and the units will toggle from °F to °C or vice versa.
24 hour and YY-MM-DD
12 hour and DD-MM-YY
Interface, Neo2 has two different operator
Altanium Neo2
Software Release Number
Hide quick links:
Advertisement
Table of Contents
