Loading A Mold Setup; Resetting A Mold Setup To The Default Settings; Copying A Mold Setup - Husky Altanium Neo2 User Manual

6.1

Loading a Mold Setup

A mold setup must be loaded before the controller can heat up the mold. Loading a mold
setup tells Neo2 the values for the setpoints, alarm bands, abort bands, etc.
NOTE:
To load a mold setup:
1.
2.
6.2

Resetting a Mold Setup to the Default Settings

NOTE:
IMPORTANT!
For safety reasons the system will not allow you to default the mold setup that is presently
loaded.
To reset a mold setup to the default settings:
1.
2.
3.
6.3

Copying a Mold Setup

The copy function is used to make a copy of a mold setup in a different mold setup number
location on the Neo2.
NOTE:
To copy a mold setup:
1.
2.
3.
4.
32
v 1.4 — September 2015
Make sure the present security level is allowed to make this change.
On the Mold Setup screen, touch the Mold Setup number for the mold setup file to load.
Touch LOAD and the selected mold setup is loaded and the Zone Data screen appears.
Make sure the present security level is allowed to make this change.
On the Mold Setup screen, touch the Mold Setup number for the mold setup to reset to
default.
Touch DEFAULT.
Acknowledge the confirmation dialog box, and the factory settings are restored. The
Change and Name fields display dashed lines.
Make sure the present security level is allowed to make this change.
On the Mold Setup screen, touch the Mold Setup number to select the mold setup file
you want to copy.
Touch COPY. The number button for that mold setup changes to magenta and the
number changes to C.
Touch the Mold Setup number to select the destination mold setup file location.
Touch PASTE. The keyboard is displayed.
Altanium Neo2
Loading a Mold Setup