Connecting The Altanium I/O Box To The Neo2 Display; I/O Box Options (Inputs) - Husky Altanium Neo2 User Manual

Figure 11-1 Altanium I/O Box
1. Front view 2. Side view

11.3.1 Connecting the Altanium I/O Box to the Neo2 Display

1.
2.
3.

11.3.2 I/O Box Options (Inputs)

The Input options that can be purchased for your Altanium/Neo2, along with a description of
each, are listed below. To activate any input, all that is required is the closure of two contacts
on the Input connector.
CAUTION!
Mechanical hazard - risk of damage to the equipment. DO NOT apply a voltage to any
of the inputs. Doing so could damage the I/O box or Neo2.
88
v 1.4 — September 2015
1
Before you can use any of the I/O options, you must connect an 8-pin communications
cable between the Altanium I/O Box and Neo2.
Connect the appropriate wires in the Input and Output cables to the required location
(for example, the injection molding machine).
Connect the I/O box to the I/O COMM Port on Neo2.
2
Connecting the Altanium I/O Box to the Neo2 Display
Altanium Neo2