Servicing The Altanium System; Altanium Card Cage - Husky Altanium Neo2 User Manual

CAUTION!
Mechanical hazard - risk of damage to the assembly. The Neo2 remote mounted
operator interface assembly is very unstable when the display is rotated in the forward
position. Attach the interface directly (using screws or other fastening hardware) to a
solid surface to prevent it from tipping over and being damaged when used in this
configuration.
The Neo2 display is used to enter and display molding parameters. There are no user-
serviceable parts inside a Neo2 display.

12.2 Servicing the Altanium System

The Altanium card cage contains everything needed to run 1 to 12 heaters in the mold. This
consists of a green Passive Backplane and 1 to 6 green
which are plugged into the Passive Backplane. The number of ICC
contains is based on the number of zones ordered with the system. All
same and can be interchanged with other
cage). The Passive Backplanes contain CAN communications address switches and can be
interchanged with other Passive Backplanes if the switches are set properly.
DANGER!
Electrical hazard – risk of serious injury or death. Do not work on mold or Altanium
without locking out and tagging the Altanium main switch. Failure to do so will result
in death or serious injury.

12.2.1 Altanium Card Cage

Figure 12-2 12 Zone Card Cage
98
v 1.4 — September 2015
2
ICC or ICC
2 3
(Intelligent Control Cards)
ICC or ICC
2 3
s
or ICC s
2
ICC
3 2
(Do not mix
ICC s and ICC
Servicing the Altanium System
Altanium Neo2
your system
3
are the
or ICC
3
s in the card