Spi Communication Protocol - Husky Altanium Neo2 User Manual

User Guide

11.6 SPI Communication Protocol

The SPI option allows the Neo2 to communicate with any central network or molding
machine that supports the Society of Plastics Industry (SPI) standard protocol.
Touch OPTIONS, and then SPI to open the SPI Communication screen.
Figure 11-5 SPI Communications Screen
Table 11-9 SPI Communication Screen Item Descriptions
SPI ID
SPI Address
SPI Baud
SPI Enabled
SPI Off
SPI Save
SPI Monitor
SPI Communication Protocol
v 1.4 — September 2015
Item
The SPI device ID. The default is 26h and cannot be changed.
The SPI address. Available settings are 32 to 254. The default is 32.
The SPI baud rate setting. Available settings are 1200, 2400, 4800, 9600,
and 19.2k. The default is 9600.
The setting to turn SPI ON or OFF. Available settings are YES and NO. The
default is NO.
The setting allows or prevents setup parameters to the injection
molding machine. Available settings are YES and NO. The default is YES.
The setting allows or prevents permanent changes. Available settings
are YES (allows changes) and NO (prevents changes). The default setting
is YES.
Access the SPI Communications Monitor screen.
Description
System Options
95