Tests and Adjustments
Information in This Chapter
Information in This Chapter
This chapter contains procedures to help you check, verify, and adjust your PNA.
• The checks verify the operation of the assemblies in your analyzer.
• The verification compares the operation of your analyzer to a gold standard.
• The adjustments allow you to tune your analyzer for maximum response.
Conventions Used for Hardkeys, Softkeys, and Menu Items
The following conventions are used in this document:
Hardkey
Softkey
Menu Item
Chapter Three at-a-Glance
Section Title
Before You Begin
About System Verification
and Performance Tests
ANSI/NCSL Z540.3–2006
and ISO/IEC 17025
Verification
Non-Standards Compliant
Verification
3-2
This represents a "hardkey", a key that is physically located on the
instrument.
This represents a "softkey", a key whose label is determined by the
instrument firmware.
This represents an item in a drop-down or pop-up menu.
Summary of Content
Items to consider or procedures to perform before testing is begun:
•
Verify the Operating Environment
•
Protect Against Electrostatic Discharge (ESD)
•
Allow the Analyzer to Warm Up
•
Review the Principles of Connector Care
Descriptions of:
•
System Specifications
•
Instrument Specifications
•
System Verification Procedure
•
Performance Tests
•
Certificate of Calibration
The ANSI/NCSL Z540.3–2006 and ISO/IEC 17025 process of
verifying your analyzer.
The Non-Standards Compliant process of verifying your analyzer.
PNA Series Microwave Network Analyzers
N5224A and N5225A
Start Page
Page 3-4
Page 3-6
Page 3-8
Page 3-9
Service Guide N5225-90001