Table of Contents
Advertisement
Repair and Replacement Procedures
Post-Repair Procedures
Post-Repair Procedures
After the replacement of an assembly, you must perform the service procedures in the order listed in
7-2.
Procedures referenced in this table are located in
otherwise.
IMPORTANT Keysight personnel: see
should be placed on the PNA.
Table 7-2
Related Service Procedures
Replaced Assembly
A1 front panel display board
A2 USB board
A3 display assembly
A4 13.5 GHz source 1 synthesizer
board
A5 26.5 GHz source board
A7, A8, A12, and A13
Doubler boards
A10 26.5 GHz source board
A14 frequency reference board
7-56
Chapter 3, "Tests and Adjustments,"
Figure 1-1 on page 1-5
Adjustments
and Other Procedures
No adjustment needed
No adjustment needed
No adjustment needed
EE Default
Adjustment: Synth Src1 only
Synthesizer Bandwidth
Adjustment
Source
Adjustment
Receiver Adjustment
Source
Adjustment
Receiver Adjustment
Source
Adjustment
Receiver Adjustment
Source
Adjustment
Receiver Adjustment
10 MHz Frequency Reference
Adjustment
Restore option data (Refer to
"Repairing and Recovering Option
Data"
in
Chapter
8.)
PNA Series Microwave Network Analyzers
to review where the calibration stickers
Verification, Performance,
and Other Tests and Procedures
Front Panel Keypad and RPG Test
A3 Display Test
in
Check for proper operation
A3 Display Test
in
Source Power Accuracy
Source Maximum Power Output
Source Power Linearity
The Operator's Check
Source Power Accuracy
Source Maximum Power Output
Source Power Linearity
The Operator's Check
Source Power Accuracy
Source Maximum Power Output
Source Power Linearity
The Operator's Check
Source Power Accuracy
Source Maximum Power Output
Source Power Linearity
The Operator's Check
Frequency Accuracy Test
Service Guide N5225-90001
N5224A and N5225A
Table
unless specified
and
Chapter 4
Chapter 4
Test
Test
Test
Test
Test
Test
Test
Test
Test
Test
Test
Test
- Quick Links:
- Table of Contents
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
