A23 Test Set Motherboard - Keysight N5224A Service Manual

PNA Series Microwave Network Analyzers
N5224A and N5225A
Rear-Panel Interconnects
10 MHz REF INPUT
10 MHz REF OUTPUT

A23 Test Set Motherboard

The A23 test set motherboard serves these functions:
• to act as an interface between the A21 CPU board and the auxiliary rear panel interconnects.
• to provide ALC signals to the A25 HMA26.5.
• to route control signals to the signal separation group. Refer to
page 5-17 for more information.
Rear Panel Interconnects
The A23 test set motherboard includes the following rear panel interconnects.
TEST SET I/O
HANDLER I/O
PWR I/O
Service Guide N5225-90001
A BNC connector that allows an external frequency reference signal to be used
to phase lock the analyzer for increased frequency accuracy.
The analyzer automatically enables the external frequency reference feature
when a signal is connected to this input. When the signal is removed, the
analyzer automatically switches back to its internal frequency reference.
A BNC connector that allows a 10 MHz reference signal, produced by the A14
frequency reference board, to be output for use in phase locking external test
equipment.
A DB-25 female connector that is used to control external test sets. The external test set
bus consists of 13 multiplexed address and data lines, three control lines, and an
open-collector interrupt line. Pin assignments are listed in
Up to 16 test sets may be "daisy-chained" on the bus at one time.
The Test Set I/O is not compatible with 8753 network analyzer test sets.
A rectangular 36-pin, female connector providing four independent parallel input/output
ports, nine control signal lines, one ground, and a power supply line. This connector has
Type 2 output pin assignments as listed in
All signals are TTL-compatible. Data input/output ports consist of two 8-bit output ports
(Port A and Port B) and two 4-bit bidirectional ports (Port C and Port D).
Connector settings can be changed using SCPI and COM commands. The settings are not
accessible from the front panel.
A DB-9 female connector. Pin assignments are listed in
Synthesized Source Group Operation
"Signal Separation Group Operation" on
Table 5-2 on page
Table 5-3 on page 5-15.
Table 5-4 on page
Theory of Operation
5-14.
5-16.
5-13