Installing The Disk Drive Tray - IBM power PS700 Problem Determination And Service Manual

Figure 24. Removing the disk drive tray
Perform the following procedure to remove the disk drive tray.
1. Read the Safety topic and the "Installation guidelines" on page 233.
2. Shut down the operating system, turn off the blade server, and remove the blade server from the
BladeCenter unit. See "Removing the blade server from a BladeCenter unit" on page 235.
3. Carefully lay the blade server on a flat, static-protective surface, with the cover side up.
4. Open and remove the blade server cover. See "Removing the blade server cover" on page 237.
5. Remove the disk drive if one is installed. See "Removing a drive" on page 241.
6. Remove the four screws that secure the drive tray ( 1 in Figure 24) to the system board and remove
the drive tray.

Installing the disk drive tray

You can install the disk drive tray.
Chapter 4. Removing and replacing blade server components
253