IBM power PS700 Problem Determination And Service Manual page 174

Table 27. A00-FF0 through A24-xxx SRNs (continued)
SRN
A05-06x
A05-07x
A05-08x
A05-10x
A05-14x
A05-19x
162
Power Systems: Problem Determination and Service Guide for the IBM Power PS700 (8406-70Y)
Description
System shutdown due to abnormally
high internal temperature.
Sensor indicates a power supply has
failed.
System shutdown due to power supply
failure.
System shutdown due to FRU that has
failed.
System shutdown due to power fault
with an unspecified cause.
System shutdown due to Fan failure.
FRU/action
1. Make sure that:
a. The room ambient temperature is within
the system operating environment.
b. There is unrestricted air flow around the
system.
c. All system covers are closed.
d. There are no fan failures
2. Check the BladeCenter management-module
event log; if an error was recorded by the
system, see "POST progress codes
(checkpoints)" on page 84.
3. If no entry is found, Replace the
system-board.
1. Check the BladeCenter management-module
event log; if an error was recorded by the
system, see "POST progress codes
(checkpoints)" on page 84.
2. If no entry is found, Replace the
system-board.
1. Check the BladeCenter management-module
event log; if an error was recorded by the
system, see "POST progress codes
(checkpoints)" on page 84.
2. If no entry is found, Replace the
system-board.
1. Check the BladeCenter management-module
event log; if an error was recorded by the
system, see "POST progress codes
(checkpoints)" on page 84.
2. If no entry is found, Replace the
system-board.
1. Check the BladeCenter management-module
event log; if an error was recorded by the
system, see "POST progress codes
(checkpoints)" on page 84.
2. If no entry is found, Replace the
system-board.
1. Check the BladeCenter management-module
event log; if an error was recorded by the
system, see "POST progress codes
(checkpoints)" on page 84.
2. If no entry is found, Replace the
system-board.