Removing The Battery - IBM power PS700 Problem Determination And Service Manual

1. Read the Safety topic and the "Installation guidelines" on page 233.
2. Shut down the operating system, turn off the blade server, and remove the blade server from the
BladeCenter unit. See "Removing the blade server from a BladeCenter unit" on page 235.
3. Open and remove the blade server cover. See "Removing the blade server cover" on page 237.
4. Remove the plastic cover for the PCI-Express (PCI-e) connector 1 .
5. Touch the static-protective package that contains the part to any unpainted metal surface on the
BladeCenter unit or any unpainted metal surface on any other grounded rack component; then, remove
the part from its package.
6. Install the expansion card 2 .
a. Slide the card into the expansion card standoff 3 on the system board.
b. Gently pivot the card down and attach it to the high speed PCI-Express connector.
7. Install and close the blade server cover. See "Installing and closing the blade server cover" on page
239.
Statement 21
CAUTION:
Hazardous energy is present when the blade server is connected to the power source. Always
replace the blade server cover before installing the blade server.
8. Install the blade server into the BladeCenter unit. See "Installing the blade server in a BladeCenter
unit" on page 236.
9. Use the documentation that comes with the expansion card to install device drivers and to perform
any configuration that the expansion card requires.

Removing the battery

You can remove and replace the battery.
Figure 22. Removing the battery
Perform the following procedure to remove the battery.
1. Read the Safety topic and the "Installation guidelines" on page 233.
2. Shut down the operating system, turn off the blade server, and remove the blade server from the
BladeCenter unit. See "Removing the blade server from a BladeCenter unit" on page 235.
250
Power Systems: Problem Determination and Service Guide for the IBM Power PS700 (8406-70Y)