IBM power PS700 Problem Determination And Service Manual page 31

Table 7. 1xxxyyyy SRCs (continued)
v Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved. If an action solves the problem, then you can stop performing the remaining actions.
v See Chapter 3, "Parts listing, Type 8406," on page 229 to determine which components are CRUs and which
components are FRUs.
1xxxyyyy
Error Description
Codes
2649 Blade power fault
2670 The BladeCenter encountered a
problem, and the blade server
was automatically shut down
as a result
2671 12V power fault in the blade
server
2672 Blades PEU3 voltage alert
2675 1.1
Reg_CPU0_P5IO2C_Vio_pGood
fault
2676 VTTA pGood fault
2677 VTTA pGood fault
2678 PROC_Vmem_controller_pGood
1.0V fault
2679 Vmem_controller_pGood 1.5V
reg fault
Action
1. Go to "Checkout procedure" on page 184.
2. Replace the system-board, as described in "Replacing the FRU
system-board and chassis assembly" on page 260.
1. Check the management-module event log for entries that were
made around the time that the PS700 blade server shut down.
2. Resolve any problems that are found.
3. Reboot the blade server.
4. If the problem is not resolved, replace the system-board and
chassis assembly, as described in "Replacing the FRU
system-board and chassis assembly" on page 260.
1. Go to "Checkout procedure" on page 184.
2. Replace the system-board, as described in "Replacing the FRU
system-board and chassis assembly" on page 260.
Perform the DTRCARD symbolic CRU isolation procedure by
completing the following steps:
1. Reseat the PCIe expansion card.
2. If the problem persists, replace the expansion card.
3. If the problem persists, go to the "Checkout procedure" on page
184.
4. If the problem persists, replace the system-board and chassis
assembly, as described in "Replacing the FRU system-board and
chassis assembly" on page 260.
The DTRCARD symbolic CRU isolation procedure is in "Service
processor problems" on page 200
1. Go to "Checkout procedure" on page 184.
2. Replace the system-board, as described in "Replacing the FRU
system-board and chassis assembly" on page 260.
1. Go to "Checkout procedure" on page 184.
2. Replace the system-board, as described in "Replacing the FRU
system-board and chassis assembly" on page 260.
1. Go to "Checkout procedure" on page 184.
2. Replace the system-board, as described in "Replacing the FRU
system-board and chassis assembly" on page 260.
1. Go to "Checkout procedure" on page 184.
2. Replace the system-board, as described in "Replacing the FRU
system-board and chassis assembly" on page 260.
1. Go to "Checkout procedure" on page 184.
2. Replace the system-board, as described in "Replacing the FRU
system-board and chassis assembly" on page 260.
19
Chapter 2. Diagnostics