Table of Contents
Advertisement
Installing the hard disk drive tray
To install the hard disk drive tray, complete the following steps.
Note: The following illustration shows how to install the hard disk drive tray in the
blade server; installing the hard disk drive tray in the MPE unit is similar.
1. Touch the static-protective package that contains the drive tray to any unpainted
2. Orient the drive tray over the four mounting holes in the system board and place
3. Install the four screws that secure the drive tray to the system board.
4. If you removed the hard disk drive while removing the drive tray, reinstall it (see
5. Install the MPE unit, if one was removed while removing the the drive tray (see
6. Install the blade server cover (see "Installing the blade server cover" on page
7. Install the blade server into the BladeCenter unit (see "Installing the blade
metal surface on the BladeCenter unit or any unpainted metal surface on any
other grounded rack component; then, remove the drive tray from the package.
the drive tray into position.
"Installing a SAS hard disk drive" on page 75).
"Installing an expansion unit" on page 71).
69).
server in a BladeCenter unit" on page 66).
Chapter 4. Removing and replacing blade server components
89
Advertisement
Table of Contents
