IBM power PS700 Problem Determination And Service Manual page 42

Table 14. B200xxxx Logical partition SRCs (continued)
v Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved. If an action solves the problem, then you can stop performing the remaining actions.
v See Chapter 3, "Parts listing, Type 8406," on page 229 to determine which components are CRUs and which
components are FRUs.
B200 xxxx
Reference Code Description
B2001142 A problem occurred during the
migration of a partition.
The migration of a partition did not
complete.
B2001143 A problem occurred during the
migration of a partition.
The migration of a partition did not
complete.
B2001144 A problem occurred during the
migration of a partition.
The migration of a partition did not
complete.
B2001148 A problem occurred during the
migration of a partition.
The migration of a partition did not
complete.
B2001150 During the startup of a partition, a
partitioning configuration problem
occurred.
B2001151 A problem occurred during the
migration of a partition.
The migration of a partition did not
complete.
B2001170 During the startup of a partition, a
failure occurred due to a validation
error.
B2001225 A problem occurred during the
startup of a partition.
The partition attempted to start up
prior to the platform fully
initializing. Restart the partition after
the platform has fully completed and
the platform is not in standby mode.
B2001230 During the startup of a partition, a
partitioning configuration problem
occurred; the partition is lacking the
necessary resources to start up.
B2001260 A problem occurred during the
startup of a partition.
The partition could not start at the
Timed Power On setting because the
partition was not set to Normal.
30
Power Systems: Problem Determination and Service Guide for the IBM Power PS700 (8406-70Y)
Action
Check for server firmware updates; then, install the
updates if available.
Check for server firmware updates; then, install the
updates if available.
Check for server firmware updates; then, install the
updates if available.
Check for server firmware updates; then, install the
updates if available.
Go to "Verifying the partition configuration" on page 186.
Check for server firmware updates; then, install the
updates if available.
Go to "Verifying the partition configuration" on page 186.
Restart the partition.
Go to "Verifying the partition configuration" on page 186.
Set the partition to Normal.