Honeywell UDC3200 Product Manual page 93

Function Prompt
Lower Display
12/04
Selections or
Range of Setting
Upper Display
TO HOLD
TO PID2
PV 2IN
RERUN
TO RUN
ToBEGIN
STOP I
MAN FS
TO LOCK
UDC3200 Universal Digital Controller Product Manual
Parameter
Definition
TO HOLD—Contact closure suspends Setpoint
Program or Setpoint Ramp. When contact reopens,
the controller starts from the Hold point of the
Ramp/Program unless the Ramp/Program was not
previously started via the
This selection applies to either loop.
TO PID2—Contact closure selects PID Set 2.
PV=INPUT 2—Contact closure selects PV = Input 2.
RERUN--Allows the Setpoint Programmer to be
reset to the initial segment of its current cycle, unit
stays in previous mode.
RUN—Contact closure starts a stopped SP Ramp or
Program. Upper left character blinks "R". Reopening
the contact puts controller in HOLD mode.
This selection applies to either loop.
EXTERNAL SP PROGRAM RESET—Contact
closure resets SP Program back to the beginning of
the first segment in the program and places the
program in the HOLD mode. Program cycle number
is not affected. Reopening switch has no effect.
This selection applies to either loop.
ATTENTION Once the last segment of the setpoint
program has timed out, the controller enters the
mode of action specified in the configuration data
and the program cannot be reset to the beginning of
the first segment by digital input closure.
INHIBIT INTEGRAL (RESET)—Contact closure
disables PID Integral (Reset) action.
MANUAL FAILSAFE OUTPUT—Controller goes to
Manual mode, output goes to the Failsafe value.
ATTENTION This will cause a bump in the output
when switching from Automatic to Manual. The
switch back from Manual to Automatic is bumpless.
When the switch is closed, the output can be
adjusted from the keyboard.
KEYBOARD LOCKOUT—Contact closure disables
all keys. Lower display shows LOCKED if a key is
pressed.
Configuration
Run Run Run
Hold Hold
Hold
key.
81