Troubleshooting - Icom IC-M93D EURO Instruction Manual

PROBLEM
You cannot turn ON the • The Battery is exhausted or over
transceiver. discharged.
• The Battery pack is not correctly attached.
Little or no sound • The squelch level is set too high.
comes from the • The volume level is set too low.
speaker. • The speaker has been exposed to water.
• Water has entered to the speaker
microphone connector.
You cannot transmit • Some channels are preset for low power
or receive only by regulations.
• The battery is exhausted.
• The battery is overcharged.
• The output power is set to low.
Scan does not start • Favorite channels are not set.
No beeps sound • Key Beep is set to OFF.
You cannot send DSC • MMSI (DSC self ID) code is not entered.
calls • DSC Switch is set to OFF.
You cannot receive • The built-in GPS antenna is obstructed,
GPS position data which interrupts the GPS signals from the
satellites.
POSSIBLE CAUSE

TROUBLESHOOTING

SOLUTION
• Recharge the battery pack.
• Correctly attach the battery pack.
• Set the squelch to the threshold point.
• Set the volume to a suitable level.
• Remove the water using the AquaQuake
function.
• Dry the speaker microphone connector.
• Change channels.
• Recharge the battery pack.
• Confirm that the battery voltage is correct.
• Push the software key below
high power.
• Set the Favorite channels.
• Turn ON the Key Beep on the
"Configuration" screen.
• Enter the MMSI (DSC self ID) code.
• Turn ON the DSC Switch in the Menu.
• Use the transceiver in a place where
nothing interrupts the satellite signal.
13
1
REF.
2
p. 61
3
p. 2
4
p. 13
5
p. 15
6
–
7
8
p. 14
9
p. 61
10
to select p. 5
11
12
p. 17
13
p. 57
14
p. 9
15
p. 42
–
16
64