Preparations; Entering The Mmsi Code - Icom IC-M93D EURO Instruction Manual

4

PREPARATIONS

■ Entering the MMSI code

The Maritime Mobile Service Identity (MMSI: DSC self ID)
code consists of 9 digits. You can only enter the code when
turning ON the transceiver for the first time.
This initial code entry can be done only once.
After entering, it can be changed only by your dealer
or distributor. If your MMSI code has already been
entered, this entry is not necessary.
1. Hold down [ ] to turn ON the transceiver.
• Three short beeps sound, and "Push [ENT] to Register your
MMSI" is displayed.
2. Push [ENT] to start entering the MMSI code.
• The "MMSI Input" screen is displayed.
L Push [CLR] twice to skip the entry.
If you skip the entry, you cannot make a DSC call. To enter
the code after skipping, turn OFF the power, and then turn it
ON again.
3. Enter the MMSI code.
TIP:
• Select a number using [◄] and [►].
• Push [ENT] to enter the selected
number.
• Select "←" or "→," to move the
cursor.
9
4. Repeat step 3 to enter all 9 digits.
5. Push the software key below [DONE] to set the entered
code.
• The "Confirmation" screen is displayed.
6. Enter your MMSI code again to
confirm.
7. Push the software key below
[DONE] to set the entered code.
L When your MMSI code is successfully
entered, "MMSI Successfully
Registered" is briefly displayed, and
then the operating screen opens.
L Your MMSI code is also displayed on
the operating screen.
NOTE: For the Dutch and German versions, entering the
ATIS ID is also required. See the next page for details.