Ipv6 In Ipv4 Tunnel - D-Link AC3200 Ultra User Manual

Section 4 - Configuration - Router Mode
The user can configure the IPv6 connection to run in IPv4 Tunnel mode. IPv6 over IPv4
tunnelling encapsulates IPv6 packets in IPv4 packets so that IPv6 packets can be sent over
an IPv4 infrastructure.
Remote IPv4 Enter the IPv4 remote address you will use.
Address:
Remote IPv6 Enter the IPv6 remote address you will use.
Address:
Local IPv4
Displays the current local IPv4 address.
Address:
Local IPv6 Enter the IPv6 local address you will use.
Address:
Subnet Prefix
Enter the subnet prefix length supplied by your ISP.
Length:
IPv6 DNS Settings
Select either Obtain DNS server address automatically or Use the
DNS Type:
following DNS address.
If Use the following DNS address is selected:
Primary DNS Enter the primary DNS server address.
Server:
Secondary DNS
Enter the secondary DNS server address.
Server:
D-Link DIR-890L User Manual

IPV6 in IPV4 Tunnel

Home Settings
DIR-890L HW:A1 FW:1.10
IPv6
All of your IPv6 Internet and network connection details are displayed on this page.
Settings >> Internet >> IPv6
My Internet Connection is: IPV6 in IPV4 tunnel
Remote IPv4 Address:
Remote IPv6 Address:
Local IPv4 Address: Not Available
Local IPv6 Address:
Subnet Prefix Length:
IPv6 DNS SETTINGS
DNS Type: Obtain a DNS server address automatically
IPv6 DNS SETTINGS
DNS Type: Use the following DNS address
Primary DNS Server:
Secondary DNS Server:
Features Management
IPv4 Save
⌵
⌵
⌵
56