Access Point - D-Link AC3200 Ultra User Manual

Section 2 - Choosing an Operation Mode
The DIR-890L operates as an Access Point when an Ethernet cable is connected from the WAN Ethernet Port to an uplink network and the device
is configured to AP Mode using the web configuration utility.
Internet Broadband
Connection Device
(e.g. DSL/Cable Modem)
Use this mode for:
• Extending your current network.
• Providing better signal for parts of your home or office that may have poor reception.
• Bringing Wi-Fi to an area it doesn't currently reach.
• Adding Wi-Fi to a wired network.
• Maximizing bandwidth.
• Creating a Wi-Fi pocket away from your existing network.
Note: Extending a network to a desired location via Ethernet may require additional cable. The maximum length of Category 5/5E cables is limited
to 100 meters (330 feet). Use a Gigabit-capable Ethernet connection where possible to ensure the best networking experience.
To use your DIR-890L as an Access Point, refer to Installation - Access Point on page 23.
D-Link DIR-890L User Manual

Access Point

Create a Wireless Network using Ethernet
Existing
Network
DIR-890L Wired and Wireless Devices
11