D-Link AC3200 Ultra User Manual page 40

Section 4 - Configuration - Router Mode
Select Dynamic IP (DHCP) to obtain IP address information automatically from your Internet
Service Provider (ISP). Select this option if your ISP does not specify an IP address to use.
Device Mode: Router Mode
My Internet Dynamic IP (DHCP)
Connection Is:
Advanced Settings
Host Name: The host name is optional but may be required by some ISPs. Leave
it blank if you are not sure.
Primary DNS
Enter the primary DNS server IP address assigned by your ISP. This
Server: address is usually obtained automatically from your ISP.
Secondary DNS Enter the secondary DNS server IP address assigned by your ISP. This
Server:
address is usually obtained automatically from your ISP.
MTU:
Maximum Transmission Unit - you may need to change the MTU for
optimal performance with your ISP.
MAC Address The default MAC address is set to the Internet port's physical interface
Clone:
MAC address on the router. You can use the drop-down menu to
replace the Internet port's MAC address with the MAC address of a
connected client.
VLAN: For more information on enabling the VLAN feature, refer to VLAN
Bridging on page 45.
Click Save when you are done.
D-Link DIR-890L User Manual
Dynamic IP (DHCP)
Home Settings
DIR-890L HW:A1 FW:1.10
Internet
Use this section to configure your Internet Connection type. There are several connection types to choose
from Static IP, DHCP, PPPoE, PPTP, L2TP and DS-Lite. If you are unsure of your connection method, please
contact your Internet service provider. Note: If using the PPPoE option, you will need to remove or disable
any PPPoE client software on your computers.
Settings >> Internet
Device Mode: Router Mode
My Internet Connection is: Dynamic IP (DHCP)
Host Name: dlinkrouter
Primary DNS Server:
Secondary DNS Server:
MTU: Auto
Mac Address Clone:
VLAN: Disabled
COPYRIGHT © 2016 D-Link
Features Management
IPv6 Save
⌵
⌵
Advanced Settings ...
⌵
⌵
<< MAC Address
35