D-Link AC3200 Ultra User Manual page 107

Section 4 - Configuration - Access Point Mode
Select Static IP if you wish to assign the access point a static IP.
Device Mode: AP Mode
My Internet Static IP
Connection Is:
IP Address:
Enter an IP address on the same subnet as your uplink router.
Subnet Mask: Enter the subnet mask used by your uplink router.
Default Gateway: Enter the IP address of your uplink router.
Primary DNS Enter the IP address of your preferred primary DNS server, usually the
Server: IP address of your uplink router.
Advanced Settings
Secondary DNS
Enter the IP address of your preferred secondary DNS server, usually
Server: the IP address of your uplink router.
MTU: Maximum Transmission Unit - you may need to change the MTU for
optimal performance with your ISP.
Click Save when you are done.
D-Link DIR-890L User Manual
Static IP
DIR-890L HW:A1
Settings >> Internet
Home
FW:1.10
Internet
Use this section to configure your Internet Connection type.
⌵
Device Mode: AP Mode
⌵
My Internet Connection is: Static IP
IP Address:
Subnet Mask:
Default Gateway:
Primary DNS Server:
Secondary DNS Server:
⌵
MTU: Auto
COPYRIGHT © 2016 D-Link
Settings Management
Save
Advanced Settings ...
102