D-Link AC3200 Ultra User Manual page 44

Section 4 - Configuration - Router Mode
Choose PPTP (Point-to-Point-Tunneling Protocol ) if your Internet Service Provider (ISP) uses
a PPTP connection. Your ISP will provide you with a username and password.
Device Mode: Router Mode
My Internet PPTP
Connection Is:
PPTP Server IP
Enter the PPTP server IP address provided by your ISP.
Address:
Username: Enter the username provided by your ISP.
Password: Enter the password provided by your ISP.
Select either Always-on, On-Demand, or Manual.
Reconnect Mode:
Maximum Idle
Enter a maximum idle time during which the Internet connection
Time: is maintained during inactivity. To disable this feature, enable Auto-
reconnect.
Advanced Settings
Address Mode: Select Static IP if your ISP assigned you the IP address, subnet mask,
gateway, and DNS server addresses. In most cases, select Dynamic IP.
D-Link DIR-890L User Manual
PPTP
DIR-890L HW:A1
Settings >> Internet
Home Settings
FW:1.10
Internet
Use this section to configure your Internet Connection type. There are several connection types to choose
from Static IP, DHCP, PPPoE, PPTP, L2TP and DS-Lite. If you are unsure of your connection method, please
contact your Internet service provider. Note: If using the PPPoE option, you will need to remove or disable
any PPPoE client software on your computers.
⌵
Device Mode: Router Mode
⌵
My Internet Connection is: PPTP
PPTP Server IP Address: IP or Domain name
Username:
Password:
⌵
Reconnect Mode: On Demand
Maximum Idle Time: 5 minutes
COPYRIGHT © 2016 D-Link
Features Management
IPv6 Save
Advanced Settings ...
39