Network; Network Settings - D-Link AC3200 Ultra User Manual

Section 4 - Configuration - Router Mode
This section will allow you to change the local network settings of the router and to configure
the DHCP settings. In the Settings menu on the bar on the top of the page, click Network.
Click Advanced Settings... to expand the list and see all of the options.

Network Settings

LAN IP Address: Enter the IP address of the router. The default IP address is 192.168.0.1.
If you change the IP address, once you click Save, you will need
to enter the new IP address in your browser to get back into the
configuration utility.
Subnet Mask: Enter the subnet mask of the router. The default subnet mask is
255.255.255.0.
Management The default address to access the router's configuration is
http://dlinkrouter.local./ Here, you can replace dlinkrouter with a
Link:
name of your choice.
Local Domain Enter the domain name (optional).
Name:
Enable DNS Relay:
Disable to transfer the DNS server information from your ISP to your
computers. If enabled, your computers will use the router for a DNS
server.
D-Link DIR-890L User Manual

Network

Home Settings
DIR-890L HW:A1 FW:1.10
Network
Use this section to configure the network settings for your device. You can enter a name for your device in
the management link field, and use the link to access web UI in a web browser. Recommend to change the
management link if there are more than one D-Link devices within the network.
Settings >> Network
Network Settings
LAN IP Address: 192.168.0.1
Subnet Mask: 255.255.255.0
Management Link: http:// dlinkrouter
Local Domain Name:
Enable DNS Relay: Enabled
DHCP Server
Status: Enabled
DHCP IP Address Range: 192.168.0. 100 to 192.168.0.
DHCP Lease Time: 10080 minutes
Enabled
Always Broadcast:
(compatibility for some DHCP Clients)
Advanced Settings
WAN Port Speed: Auto
Enabled
UPnP:
IPv4 Multicast Streams: Enabled
IPv6 Multicast Streams Enabled
COPYRIGHT © 2016 D-Link
Features Management
Save
.local/
Advanced Settings ...
199
⌵
68