D-Link AC3200 Ultra User Manual page 42

Section 4 - Configuration - Router Mode
Select PPPoE if your ISP provides and requires you to enter a PPPoE username and password
in order to connect to the Internet.
Router Mode
Device Mode:
PPPoE
My Internet
Connection Is:
Username: Enter the username provided by your ISP.
Password: Enter the password provided by your ISP.
Reconnect Mode: Select either Always-on, On-Demand, or Manual.
Maximum Idle Enter a maximum idle time during which the Internet connection
Time:
is maintained during inactivity. To disable this feature, enable Auto-
reconnect.
Advanced Settings
Select Static IP if your ISP assigned you the IP address, subnet mask,
Address Mode:
gateway, and DNS server addresses. In most cases, select Dynamic IP.
Dynamic IP
Service Name: Enter the ISP service name (optional).
Primary DNS Enter the primary DNS server IP address assigned by your ISP.
Server:
Secondary DNS
Enter the secondary DNS server IP address assigned by your ISP.
Server:
MTU: Maximum Transmission Unit - you may need to change the MTU for
optimal performance with your ISP. The recommended setting is Auto.
D-Link DIR-890L User Manual
PPPoE
DIR-890L HW:A1
Settings >> Internet
Home Settings
FW:1.10
Internet
Use this section to configure your Internet Connection type. There are several connection types to choose
from Static IP, DHCP, PPPoE, PPTP, L2TP and DS-Lite. If you are unsure of your connection method, please
contact your Internet service provider. Note: If using the PPPoE option, you will need to remove or disable
any PPPoE client software on your computers.
⌵
Device Mode: Router Mode
⌵
My Internet Connection is: PPPoE
Username:
Password:
⌵
Reconnect Mode: On demand
Maximum Idle Time: 5 minutes
COPYRIGHT © 2016 D-Link
⌵
Address Mode: Dynamic IP
Service Name:
Primary DNS Server:
Secondary DNS Server:
⌵
MTU: Auto
Mac Address Clone:
VLAN: Disabled
COPYRIGHT © 2016 D-Link
Features Management
IPv6 Save
Advanced Settings ...
⌵
<< MAC Address
37