Panasonic CS-VZ9SKE Service Manual page 113

17.4.12 H53 (Aluminium Electric Heater (Heatcharge) Temperature Sensor Error)
Troubleshooting
Check for bad connection of the sensor connector.
Check for the characteristics of the sensor.
Refer to the characteristic table for electronic circuit diagram.
(Remove the connector and check the resistance value of the sensor.)
For the heat exchanger temperature sensor of some models, the sensor is not connected by a
connector but it is directly soldered to the board.
In this case, replace the control board.
Diagnosis Procedures and Cause
No abnormality is observed
No abnormality is observed
Disconnection/Imperfect
connection of the connector
An abnormality is observed
113
Measures to be Taken
Fix the problem.
Replace the sensor.
Replace the control board.