Table of Contents
Advertisement
OTHERS menu
You can alter several device parameters that allow you
to match the functioning of the multiplexer to your
own particular needs.
8.OTHER SETTINGS
BUZZER
MONITOR OUT2
CH NO.DISPLAY TIME 10SEC
BACKGROUND COLOR
H.POSITION
V.POSITION
REFRESH
BUZZER
This feature lets you enable or disable the built-in
alarm buzzer.
Possible settings:
ON
Alarm tone enabled
OFF Alarm tone disabled
MONITOR OUT2
You can decide whether the monitor connected to
output No. 2 should display independent camera
images and sequences or be synchronized with the
main monitor.
Possible settings:
SPOT
Camera images can be displayed on the
second monitor independently of the main
monitor in full-screen mode or shown as part
of an automatic sequence.
1
The second monitor always displays the
same image as the main monitor.
CH NO.DISPLAY TIME
You can decide the time that should elapse before
superimposed additional information should automati-
cally disappear from the screen (see page 14).
Possible settings:
1SEC
(1 second)
5SEC
(5 seconds)
ZS-SX Series
ON
SPOT
BLUE
0
0
PTN1
3SEC
(3 seconds)
10SEC
(10 seconds)
4-SEG CH 9 DISP (applies to ZS-SX109 only)
Allows you decide – in the case of activated quad-
splitting – whether the camera image from input No. 9
should be displayed or skipped. This setting applies to
manual selection of camera groups and automatic
sequencing.
Possible settings:
ON
When changing, the following camera images
are displayed:
Cameras 1 ... 4,
Cameras 5 ... 8,
Camera 9
OFF When changing, the following camera images
are displayed:
Cameras 1 ... 4,
Cameras 5 ... 8,
Camera 9 is skipped
BACKGROUND COLOR
Allows you to choose the color of the blank screen
display when no video signal is active for the selected
input.
Possible settings:
BLACK
BLUE
H.POSITION and V.POSITION
Allows you displace the image horizontally and verti-
cally on the screen when necessary. Target cross-hairs
are superimposed on-screen for the purpose of orien-
tation.
Possible settings:
–7 ... 0 ... +7
REFRESH
Normally PTN1 is selected. You can select other
setting if required, e.g. in case of video problems.
Possible settings:
PTN1
PTN2
Programming
41
Advertisement
Table of Contents
