Table of Contents
Advertisement
Operation
Recording
(only in multiplexer mode)
You can use a connected VCR unit to record selected
camera images. The camera images to be recorded
are established at the programming stage. The re-
cording function does not affect monitor configuration
in any way.
• Select CAMERA or VCR operating mode.
• Activate the RECORD function on the VCR unit.
Note
You will find important additional information
on recording in the manual supplied with
your VCR unit.
Playback
(only in multiplexer mode)
You can reproduce video recording from either of the
two connected VCR units. Video recordings can be
reproduced in full-screen mode or shown on a split
screen (see page 10).
Note
You will find important additional information
on playback functions in the manual supplied
with your VCR unit.
• Select VCR mode.
• Set the VCR switch to position 1 or 2 to select one
of the video recorders.
• Activate the PLAY function on the VCR unit.
Any alarm messages that have been recorded will be
reproduced during playback. The alarm button will
flash red and the alarm messages will be superim-
posed on the images from the corresponding cameras
(see page 16). You can also use the zoom and freeze-
frame functions during playback of recordings (see
pages 12/13).
Note
The video recorder will continue running even
if freeze-frame (FREEZE) is active. When
freeze-frame is deactivated, playback contin-
ues from the current position of the tape.
18
ZS-SX Series
Advertisement
Table of Contents
