Table of Contents
Advertisement
Programming
OPTION menu
You can enter the various user-specific settings de-
scribed below.
1.USER OPTION
10-SEG CAMERA SELECTION
LOWER LEFT
LOWER RIGHT
SEQUENCE DWELL TIME
INITIAL(CAMERA)
REC PTN SEL
10-SEGMENT CAMERA SELECTION
(only in multiviewer mode)
The multiplexer supports a special 10-segment split-
screen feature, with the display divided into two large
segments and eight smaller ones. The camera images
in these two segments are updated more often than
their smaller counterparts, making them virtually real-
time displays.
Within the 10-segment format, you can decide which
camera images are to be displayed in the two larger
segments. However, the screen layout (eight small
segments at the top, two large segments at the bot-
tom) cannot be altered.
Possible settings:
LOWER LEFT
LOWER RIGHT
01 ... 09
Camera ID number (ZS-SX109)
01 ... 16
Camera ID number (ZS- DX116)
SEQUENCE DWELL TIME
You can adjust the dwell time for automatic image
sequencing separately for each of the two monitor
outputs. As soon as this dwell period expires, the
multiplexer switches over to the next camera image in
the sequence.
Possible settings:
OUT1
Monitor output No. 1
OUT2
Monitor output No. 2
1 ... 99 SEC (= seconds)
34
01
05
OUT1
05SEC
OUT2
15SEC
10SEG 2
1
INITIAL (CAMERA) (only in multiviewer mode)
INITIAL (VCR) (only in multiplexer mode)
This feature lets you decide which image is to be
activated when the multiplexer is switched on. The
selection becomes effective whenever the multiplexer
is switched on or off.
The selection can be made separately for live images
(INITIAL CAMERA) and video recordings (INITIAL
VCR).
Possible settings
(* applies to ZS-SX116 only,
° only in multiviewer mode):
FULL1
Full-screen (camera No. 1 in this case)
SEQ
Automatic sequencing
4SEG 1
Quad-splitting, cameras 1... 4
4SEG 2
Quad-splitting, cameras 5 ... 8
4SEG 3
Quad-splitting, cameras 9 ... 12
4SEG 4
Quad-splitting, cameras 13 ... 16 *
4SEG SEQ Quad-splitting with autom. sequencing
9SEG 1
9-segment split screen, cameras 1 ... 9
9SEG 2
9-segment split screen, cameras 10 ... 16 *°
10SEG 1
10-segment split screen, cameras 1 ... 8°
10SEG 2
10-segment split screen, cameras 9 ... 16 *
16SEG
16-segment split screen, cameras 1 ... 16 *
REC PTN SEL
(only in multiplexer mode)
This feature lets you decide which recording pattern
the multiplexer should use. The available patterns are
set up using the REC PTN menu (see page 39).
Possible settings:
1
Recording pattern 1
2
Recording pattern 2
Note
Selection within this menu item is only possi-
ble if the value INT has been activated for the
REMOTE CONTROL REC PATTERN param-
eter within the REMOTE menu (see page 37).
ZS-SX Series
Advertisement
Table of Contents
