Table of Contents
Advertisement
Installation
Connecting peripheral equipment
z
Important!
Unplug all items from the network before
connecting them to each other.
Monitors
You can connect two monitors to the multiplexer
directly. All the digital functions of the multiplexer (e.g.
zoom, pan, tilt and freeze-frame) are available to the
monitor connected to socket MONITOR OUT 1. The
basic function of the monitor connected to socket
MONITOR OUT 2 is to display unprocessed camera
images. You can however configure output 2 in such a
way that both monitors display the same images (see
page 41).
The on-screen menus used for configuration and
programming purposes are always superimposed
onto both monitors.
• Use a BNC-type cable to connect the socket
MONITOR 1 and if applicable MONITOR 2 to the
BNC inputs of the monitors.
Video recorder
You can connect either a single video recorder or two
VCR units simultaneously to the multiplexer. This
allows you to switch to the other VCR when the end
of the tape of one VCR is reached. The unit is fitted
with a BNC-type video IN and video OUT socket for
each video recorder.
• Connect either one or two video recorders to the
VCR IN and VCR OUT sockets.
Cameras
You can connect up to 9 (ZS-SX109) or 16 (ZS-
SX116) cameras to the multiplexer. Each camera input
disposes of a looped output signal at the correspond-
ing BNC-type OUT socket.
Note
The incoming video signals are automatically
closed at 75 Ohm, if no other item of equip-
ment is connected to the corresponding
output socket. No additional termination is
required.
22
ZS-SX Series
Advertisement
Table of Contents
