Table of Contents
Advertisement
Programming
Check before starting the programming procedure
that all peripheral devices (cameras, monitors, external
alarm signal sources) are properly connected.
The multiplexer and all ancillary equipment must be
switched on.
Note
Access to the menus is blocked whenever
an alarm function is active (indicated by
flashing red alarm button).
Basic operation
Control buttons
The various functions of the multiplexer are simple to
program thanks to the on-screen menu-based sys-
tem. Menu entries are made using the control buttons
located on the front of the unit.
Note
If the menus on your particular machine differ
from those described here, it is possible that
a different version of the software has been
installed. (Please refer to version information
on the rear of the pack).
Menu navigation is carried out using just the following
buttons:
MENU
for activating the on-screen menu
for moving up one level within the menu
for canceling the menu
Cursor keys for moving from one menu item to
another
SELECT
for altering values
Starting the programming procedure
Once the unit is switched on, the camera image will
be displayed on the monitors and programming can
begin.
• Keep the MENU button pressed for about three
seconds to display the main menu.
• Press the MENU button again to escape from the
main menu.
If no entries are made, the menus will be cancelled
automatically after a short time.
ZS-SX Series
MENU
1.NORMAL MENU
2.QUICK SETUP MENU
Programming
31
Advertisement
Table of Contents
