Control Panels
Notice!
Use either the terminal strip wiring or interconnect wiring to the control panel. Do not use
both. When connecting multiple modules, you can combine terminal strip and interconnect
wiring connectors in series.
8.4.4
Diagnostic LEDs
The B450 includes the following on-board LEDs to assist with troubleshooting:
–
–
–
The plug-in module also includes LEDs for troubleshooting and status.
Flash pattern
once every 1 sec
3 quick flashes every 1 sec
Tab. 8.9: Heartbeat LED descriptions
Flash pattern
RX (Receive)
TX (Transmit)
Tab. 8.10: RX and TX LED descriptions
Refer to the module's Installation and Operation Guide for more information on the LEDs and
troubleshooting.
8.5
Compatible receivers for IP communication
When the control panel is configured to report in Modem4 format, the Conettix central station
receiver/gateway and the D6200 Programming/Administration Software may require an
update. Requirements are shown in the Modem4 requirements table below.
Bosch Security Systems, Inc.
Heartbeat (system status).
RX (receive).
TX (transmit).
On Steady
Off
Installation and System Reference Guide
Function
Normal state. Indicates normal operation.
Flashes
Communication error state. Indicates a bus
communication error with the control panel.
Trouble state. Indicates a trouble condition
exists. Examine the other LEDs to determine
the trouble condition.
LED trouble state. Indicates the module is
not powered up, or there is a failure in the
module. Check for proper installation.
Function
Occurs every time a packet is received on-air.
Flashing
Occurs every time a packet is transmitted on-
air.
Flashing
IP communications | en
57
2016.06 | 08 | F.01U.303.996