Bosch B9512G Installation And System Reference Manual page 133

Control Panels
6.
SIM Username
B91x/B92x keypads configuration of SIM Username
1.
2.
3.
4.
5.
6.
B93x/B94x keypads configuration of SIM Username
1.
2.
3.
4.
5.
6.
SIM Passcode
B91x/B92x keypads configuration of SIM Passcode
1.
2.
3.
4.
5.
6.
B93x/B94x keypads configuration of SIM Passcode
1.
2.
3.
4.
5.
6.
SIM PIN
B91x/B92x keypads configuration of SIM PIN
1.
2.
3.
Bosch Security Systems, Inc.
When the keypad shows Parameter Saved, escape from the menu.
Enter the installer passcode, and then open the [1] Installer menu.
Go to [1] Program > [2] Network > [2] Cellular > (choose the SDI2 cellular module or
plug-in module) > [2] SIM Username. The keypad shows the current configuration.
Press [ENTER] to edit the configuration.
Delete existing characters, if necessary, and then enter the new characters.
Press [ENTER] to save the changes.
When the keypad shows Parameter Saved, escape from the menu.
Enter the installer passcode, and then open the [1] Installer menu.
Go to [1] Program > [2] Network > [2] Cellular > (choose the SDI2 cellular module or
plug-in module) > [2] SIM Username. The keypad shows the UPnP current configuration.
Press [Edit] to edit the configuration.
Delete existing characters, if necessary, and then enter the new characters.
Press [Save] to save the programming.
When the keypad shows Parameter Saved, escape from the menu.
Enter the installer passcode, and then open the [1] Installer menu.
Go to [1] Program > [2] Network > [2] Cellular > (choose the SDI2 cellular module or
plug-in module) > [3] SIM Passcode. The keypad shows the current configuration.
Press [ENTER] to edit the configuration.
Delete existing characters, if necessary, and then enter the new characters.
Press [ENTER] to save the changes.
When the keypad shows Parameter Saved, escape from the menu.
Enter the installer passcode, and then open the [1] Installer menu.
Go to [1] Program > [2] Network > [2] Cellular > (choose the SDI2 cellular module or
plug-in module) > [3] SIM Passcode. The keypad shows the UPnP current configuration.
Press [Edit] to edit the configuration.
Delete existing characters, if necessary, and then enter the new characters.
Press [Save] to save the programming.
When the keypad shows Parameter Saved, escape from the menu.
Enter the installer passcode, and then open the [1] Installer menu.
Go to [1] Program > [2] Network > [2] Cellular > (choose the SDI2 cellular module or
plug-in module) > [4] SIM PIN. The keypad shows the current configuration.
Press [ENTER] to edit the configuration.
Installation and System Reference Guide
Keypad Installer menu | en 133
2016.06 | 08 | F.01U.303.996