Address Settings; Supervision; Installation And Control Panel Wiring (Keypads) - Bosch B9512G Installation And System Reference Manual

Control Panels
For more information on creating custom functions, assigning authority levels to the functions,
assigning custom functions to a keypad's Shortcuts, and other methods for initiating custom
functions, refer to RPS Help or the control panel Program Entry Guide.
9.1.10

Address settings

The control panel uses the keypad's address setting for communication and bus supervision.
If multiple keypads reside on the same system, each keypad must have a unique address even
when on different buses.
B94x/B93x/B92x keypads
B93x and B92x keypads use two hardware address switches. The B94x keypads use two
virtual (on-screen) switches that mimic the hardware switches. For single-digit addresses 1
through 9, set the tens switch to 0. The figure shows the keypad switches set to 1:
B91x and SDI keypads
B91x and SDI keypads use dip switches to set the address. For more information, refer to
B91x address settings, page 171 and SDI keypad address settings, page 173.
9.1.11

Supervision

The control panel supervises all enabled SDI2 keypads.
The control panel supervises SDI keypads when the Supervision parameter (within KEYPADS
\Keypad Assignments) is enabled in RPS.
Any failure to receive an expected response from a keypad results in a system fault (missing
keypad) shows on all keypads. The control panel sends a keypad missing report to the central
station, if configured.
9.1.12

Installation and control panel wiring (keypads)

Ensure that there is enough power for the keypad and other powered devices you want
connected to the system.
Refer to On-board outputs, page 66.
Installing a keypad:
1.
2.
3.
4.
5.
Wire to the control panel
For maximum wire lengths, refer to the SDI2 Bus and SDI Bus sections of the table in
Specifications, page 164 and the installation instructions for each keypad.
SDI2 keypads
Connect SDI2 keypads to the SDI2 bus by parallel wire run from the control panel to each
keypad, wire from keypad to keypad, or a combination of the two.
SDI keypads
Connect SDI keypads to the SDIx bus by parallel wire run from the control panel to each
keypad, wire from keypad to keypad, or a combination of the two.
Bosch Security Systems, Inc.
Open the keypad.
Set the keypad address using the address switches
Use the provided anchors and screws to mount the keypad base on the wall.
Pull the necessary wiring through the mounting plate. Refer to Wire to the control panel.
Install the keypad on the base.
Installation and System Reference Guide
Keypads, keyswitches, keyfobs and transmitters | en 61
2016.06 | 08 | F.01U.303.996