Points Menu Parameters - Bosch B9512G Installation And System Reference Manual

Control Panels
7.
B93x/B94x keypads configuration of Users
1.
2.
3.
4.
5.
6.
7.
20.1.16

[7] Points menu parameters

Use the parameters in this menu to assign a Point Source and a Point Index to each point.
The Point Source parameter assigns the point to a device (on-board, Octo-input, and wireless
are examples). The Point Index (point profile) determines how the point operates.
Point Source selections
Unassigned
Octo-input
Wireless
On-board
POPEX
*The B426 and the "E" variants do not support IP cameras.
Point Index selections
Assign a Point Index to a point by selecting the Point Index number. The tables below show the Point Index
number and default configuration for each Point Index. You must use RPS to configure the Point Index
parameters..
Point Indexes (point profiles) 1 through 8
Point Index Text defaults (the second language text defaults are blank):
Point Index Number
Point Index 1
Point Index 2
Point Index 3
Point Index 4
Point Index 5
Point Index 6
Point Index 7
Bosch Security Systems, Inc.
When the keypad shows Parameter Saved, escape from the menu.
Enter the installer passcode, and then open the [1] Installer menu.
Go to [1] Program > [6] Users menu. The keypad shows the user passcode for the
selected user.
Use /[PREV] or /[NEXT] to toggle between user 000 (service user) and user 001 and
go to the user you want to edit.
Press [Edit] to change the passcode.
Delete existing characters, if necessary, and then enter the new characters.
Press [Save].
When the keypad shows Parameter Saved, escape from the menu.
Default Text (first language)
24-hr Instant on Open/Short
24-hr Invisible/Sil on Short
Pull Station
Smoke Detector
Smoke Detector w/Verification
Bell Supervision - D192G
Part On: Instant
Installation and System Reference Guide
ZONEX
Output
Keypad
IP Camera*
Door
Keypad Installer menu | en 141
2016.06 | 08 | F.01U.303.996