Installation Checklist - Bosch B9512G Installation And System Reference Manual

30 en | Installation checklist
4

Installation checklist

Before installing and operating the control panel, read these instructions. Failure to follow
these procedures may cause the device not to function properly. Bosch Security Systems Inc.
is not responsible for any devices that are improperly installed, tested, or maintained.
This document does not contain special information about local requirements and safety
issues. Information on such issues is provided only to the extent that it is needed for
operation of the device. Ensure that you are familiar with all safety-related processes and
regulations in your area. This also includes how to act in the event of an alarm and the initial
steps to take if a fire breaks out. The operating instructions should always be available on site.
It is a required part of the system and must be given to the new owner if the system is ever
sold.
Use the workflow and checkboxes below as you complete steps. Each step includes
references for more detailed information.
–
–
–
–
–
–
–
–
–
–
–
–
–
–
2016.06 | 08 | F.01U.303.996
Install the enclosure and wiring label
Install the enclosure and wiring label
Install the control panel
Mount the control panel, page 32
Connect earth ground, page 32
Install and wire for telephone communication
Telephone communications, page 44
Install and wire for IP communications
IP communications, page 48
Install and wire the battery and the transformer
Power supply, page 36
Begin to charge the battery while you install other devices
Charge the battery
Install and wire arming devices
Keypads, keyswitches, keyfobs and transmitters, page 59
Install and wire outputs
On-board outputs, page 66
Off-board outputs, page 69
Install and wire inputs
On-board points, page 72
Off-board points, page 75
Wireless modules, page 83
Complete the installation
Program and test the control panel, page 88
Installation and System Reference Guide
Control Panels
Bosch Security Systems, Inc.