Disable Programming Menu - Bosch B9512G Installation And System Reference Manual

152 en | Keypad Installer menu
RFID
B91x/B92x keypads configuration of RFID
1.
2.
3.
4.
5.
6.
7.
8.
B93x/B94x keypads configuration of RFID
1.
2.
3.
4.
5.
6.
7.
8.
20.1.17

[8] Disable Programming menu

The Keypad Installer menu is enabled by default. When enabled, the Service User (Authority
Level 15) has authority to access the menus. If you disable Keypad Programming, the Service
User cannot access the menus. In this menu, you can disable Keypad Programming.
Notice!
You can continue using the current programming session. Disabling Keypad Programming
applies once you exit the current session.
Keypad Programming
B91x/B92x keypads configuration of Keypad Programming
1.
2.
3.
4.
5.
2016.06 | 08 | F.01U.303.996
Enter the installer passcode, and then open the [1] Installer menu.
Go to [1] Program > [7] Points option. The keypad toggles between showing the point
index and point source for the selected point.
Use [PREV] or [NEXT] to go to the desired point, or enter the point number.
Press [ENTER] to edit the point and then press [NEXT] to go to the RFID option if the
source is Wireless.
Press [ENTER] to edit the RFID for the selected.
Delete existing characters, if necessary, and then enter the new numbers listed on the
wireless device.
Press [ENTER] while viewing the desired source to save the programming.
When the keypad shows Parameter Saved, escape from the menu.
Enter the installer passcode, and then open the [1] Installer menu.
Go to [1] Program > [7] Points option. The keypad shows the index for the selected
point.
Use /[PREV] or /[NEXT] to go to the desired point, or enter the point number.
Press [Source] to view and edit the source. If the source is Wireless, the [RFID] softkey
appears.
Press [RFID] to edit the RFID.
Delete existing characters, if necessary, and then enter the new numbers listed on the
wireless device.
Press [Save] to save the programming.
When the keypad shows Parameter Saved, escape from the menu.
Enter the installer passcode, and then open the [1] Installer menu.
Go to [1] Program > [8] Disable Programming. The keypad shows that programming is
enabled.
Press [ENTER] to disable keypad programming, and then press [NEXT] to go to the No
option.
Press [ENTER] to save the programming.
When the keypad shows Parameter Saved, escape from the menu.
Installation and System Reference Guide
Control Panels
Bosch Security Systems, Inc.