118 en | Keypad Installer menu
Caution!
Any points programmed as fire supervisory points are latching.
!
Point Index
Point Source
Point Area
Point Name
1.
2.
3.
4.
5.
6.
7.
8.
9.
10. Press Save or Enter. The keypad shows Parameter saved.
11. Press Area or use
12. Press Edit or Enter to edit the area for the selected point.
13. Use
14. Press Save or Enter. The keypad shows Parameter saved.
15. Press Name or use
16. Press Edit or Enter to edit the name for the selected point.
17. Delete the existing characters, if necessary, and enter the new characters.
18. Press Save or Enter. The keypad shows Parameter saved.
20.1.17
[8] Disable Programming menu
The Keypad Installer menu is enabled by default. When enabled, the Service User (Authority
Level 15) has authority to access the menus. If you disable Keypad Programming, the Service
User cannot access the menus. In this menu, you can disable Keypad Programming.
Notice!
You can continue using the current programming session. Disabling Keypad Programming
applies once you exit the current session.
Keypad Programming
1.
2.
3.
2017.04 | 15 | F.01U.287.180
Enter the installer passcode, and then open the [1] Installer Menu.
Go to [1] Programming Menu > [7] Points.
Enter the point number and press Enter, or use
desired point.
Press Edit or Enter to edit the index for the selected point.
Use
/Previous or
/Next to go the desired index.
Press Save or Enter. The keypad shows Parameter saved.
Press Source or use
Press Edit or Enter to edit the source for the selected point.
Use
/Previous or
/Next to go the desired source.
/Next to go to the area option.
/Previous or
/Next to go to the source option.
Enter the installer passcode, and then open the [1] Installer Menu.
Go to [1] Programming Menu > [8] Disable. The keypad shows that programming is
enabled.
Depending on keypad model:
Press Edit and then press No.
-or-
/Next to go to the source option.
/Next to go the desired area.
Installation Manual
/Previous or
/Next to go to the
Bosch Security Systems, Inc.
Control Panels