Replacing The Base Chassis - HP BL536A User's & Service Manual

Replacing the base chassis

CAUTION:
can damage the chassis.
1. The shipping lock prevents the robotic transport mechanism from moving during shipment.
You must remove the shipping lock before powering on the device. The shipping lock is held
in place with a piece of tape and is located in the top center of the new chassis. After the
shipping lock is removed, it should be stored on the back panel of the chassis for future use.
To remove and store the shipping lock:
a. Locate the tape and lock at the top of the chassis (see
Figure 86 Shipping lock location
b. Remove the tape, then remove the lock.
c. Store the lock on the back panel of the device.
2. Mount the Autoloader in a rack or in the tabletop conversion cover.
To mount the Autoloader in a rack:
a. With assistance, slide the Autoloader onto the metal rails that are already in position in
the rack.
b. From the front of the device, secure the front bezel to the rack using a #2 Phillips screw
driver placed through the small holes in the mounting bracket to tighten the captive screws
on each side of the device.
Figure 87 Securing the Autoloader to the rack
To replace the tabletop conversion cover:
a. Set the new base chassis on a sturdy surface in front of the cover.
b. Slide the chassis into the cover until the front panel of the chassis is aligned with the cover.
c. Tighten the captive screws on the chassis front panel until the cover is secure.
Lift the chassis from the side edges. Lifting the chassis from the magazine openings
Figure 86 (page 137)).
Removing and replacing the base chassis 137