Configuration; Changing The System Configuration - HP BL536A User's & Service Manual

Figure 36 Status: Inventory: Media details pane
In the media details pane,
Slot # — lists "Mailslot" or the index number of each slot in the magazine from lowest to
highest.
Attn — indicates an attention state for storage slots or provides information on the mailslot
state.
Status — Full or Empty.
In Drive — shows when the tape from this slot is in a drive.
Label — the bar code label data for the tape in the slot.
Media Loads — the number of times this tape has been loaded into a drive in its lifetime. This
field may be blank if the tape has not been loaded into a drive in this device or if the inventory
has changed.
Comment — any additional information about the tape in the slot (for example, Clean Tape
if the cartridge is a cleaning tape).

Configuration

Changing the system configuration

Use the Configuration: System page (page 47)
System configuration changes are only applied after the Apply Selections or the Submit button is
selected. After making the selection, a warning page informs you of the impact of the proposed
change. In some cases a pop-up screen asks you to confirm the change. Many changes also require
the device to reboot. You may need to click Refresh to see the changes.
46 Operating the Tape Autoloader
to modify the system configuration.