Configuring Hp Systems Insight Manager For The Tape Autoloader; Changing The Administrator Password - HP BL536A User's & Service Manual

Community Name — a string used to match the SNMP management station and device. It
must be set to the same name on both the management station and the Autoloader. The default
community name is public.
SNMP Trap Notification Filter — the types of events for which the device should send SNMP
traps.
IPv4 or IPv6 Management Station — IP address of the Command View TL management station.
Only one management station can be configured. If both IPv4 and IPv6 IP addresses are
provided, only the IPv4 address will be used

Configuring HP Systems Insight Manager for the Tape Autoloader

The Autoloader uses the HP NetCitizen MIB, which is supported by HP Systems Insight Manager
(SIM) and many other applications. To detect the Tape Autoloader using a remote management
application, such as HP SIM, you must first add the IP address for the management system as an
SNMP target using the network configuration. SNMP queries are only accepted from configured
targets.
To configure the Autoloader for use with HP SIM:
1. From the RMI, add the HP SIM management station as an SNMP target.
2. If the Autoloader IP address is in an HP SIM automatic discovery IP address list, the SIM
management station will detect the Autoloader at the next scheduled scan.
To configure HP SIM for manual discovery:
1. In the HP SIM toolbar, click Options > Discovery.
2. Click the Manual tab.
3. Enter the Autoloader's IP address or system name.
SIM 5.1 will automatically detect the system type and product name.
To manually identify the Autoloader with SIM 5.0 and older:
1. In the HP SIM System and Event Collections pane, click Systems by Type.
2. In the Systems by Type pane, click All systems.
3. Click the link with the IP address or name of the Tape Autoloader.
4. Click the Tools & Links tab.
5. Click Edit System Properties.
6. Set System Type to Tape Library.
7. Enter the Product Model of your Tape Autoloader.
8. Click OK.

Changing the administrator password

Use the Configuration: Password page
OCP.
NOTE: You must set the administrator password with the OCP before you can access administrator
functionality in the RMI. See
Password) (page
54 Operating the Tape Autoloader
to change the administrator password for the RMI and
Changing the administrator password (Configuration > Change Admin
72).