Operations; Moving Media - HP BL536A User's & Service Manual

SNMP: disabled, but saved addresses do not change
E-mail notification: disabled, but configurations retained
The following settings are not reset:
Administrator password
Network settings (network is always enabled and the network addresses are retained)
Date and time
To save the device configuration to a file, click Save and follow the instructions on the RMI to
specify a file location.
To restore the device configuration from a file, browse to the location of the saved configuration
file and click Restore.
The configuration settings that are saved to file are:
Administrator password
Mailslot configuration
All network settings, including DHCP, DNS, IPv4 and IPv6 addresses
Barcode reader label length and barcode reader alignment
Reserved slots
Autoloader mode
All drive configuration settings
Auto clean
SNMP addresses and configurations
Log tracing configuration
Email notification configuration (SMTP address, email address, filter level)
Option to allow the magazine access without the administrator password
Option to ignore the barcode media ID
Encryption and security settings

Operations

Moving media

Use the Operations: Move Media page
IMPORTANT:
backups are complete before moving media.
58 Operating the Tape Autoloader
Moving media manually can interfere with backup software operations. Ensure
to move tape cartridges within the device.