Status; Viewing Dynamic Device Information - HP BL536A User's & Service Manual

IPv4 DNS Server 1 and IPv4 DNS Server 2 — addresses of the configured DNS servers used
when DHCP Addressing is not Enabled.
DHCPv4 Addressing — When Enabled, the device will request an IP address from a DHCP
server each time the device is booted.
IPv4 Address — the Autoloader network address
Subnet Mask — The network mask of the autoloader controller used when DHCP Addressing
is not Enabled.
Default Gateway — the gateway used when DHCP Addressing is not Enabled.
When IPv6 Addressing is Enabled, you can see, but not modify:
Stateless Addressing — when Enabled, the device will generate an address for itself based
on the routing information obtained from a router advertisement and the MAC address. The
device can manage up to five global addresses at the same time, which can be assigned from
different routers.
DHCPv6 Addressing — when Enabled, the Autoloader will request an IP address from a DHCP
server each time the device is booted.
Static Addressing — when Enabled, the device will use a statically-configured address.
Static Assigned Address — the IPv6 address when Static Addressing Enabled is On.

Status

Viewing dynamic device information

The Status: Autoloader page
Refresh, the status is updated immediately.
Figure 31 Status: Autoloader page
You can see, but not modify, the following:
42 Operating the Tape Autoloader
displays dynamic information about the device. When you click