Condensation Has Formed Inside The Printer; Date And Time Are Incorrect - Xerox WorkCentre 6655i User Manual

Troubleshooting

Condensation Has Formed Inside the Printer

Moisture can condense inside a printer where the humidity is above 85% or when a cold printer is
located in a warm room. Condensation can form in a printer after it has been sitting in a cold room that
is heated quickly.
Probable Causes
The printer has been sitting in a cold room.
The relative humidity of the room is too high. • Reduce the humidity in the room.

Date and Time Are Incorrect

Probable Causes
The Date and Time Setup is set to Manual
(NTP Disabled).
The time zone, date, or time is set incorrectly. Set the time zone, date, and time manually. For details, see
®
218 Xerox WorkCentre
User Guide
Solutions
• Allow the printer to acclimate for several hours before operation.
• Allow the printer to operate for several hours at room
temperature.
• Move the printer to a location where the temperature and
relative humidity are within the operating specifications.
Solutions
To change the Date and Time to Automatic, enable NTP in Xerox
CentreWare
Administrator Guide at www.xerox.com/office/WC6655docs.
the Date and Time at the Control Panel
®
6655/6655i Color Multifunction Printer
®
Internet Services. For details, see the System
Setting
on page 46.
®