Daily Set-Up - Wells M4200 Owner's Manual

DAILY SET-UP PROCEDURES
1. Make sure the power cord is plugged into the appropriate
power supply receptacle.
2. Place the ON/OFF switch in the ON position. A double "beep" will
sound, display will read WELLS BLOOMFIELD for 3 seconds,
then display oven status:
a. Display will read TOO COOL and the heat light will glow during
warm-up.
b. Display will read OVEN READY and the heat light will go out
when oven temperature reaches the setpoint.
c. Heat light will cycle as heating elements cycle to maintain
desired temperature.
3. To view actual and setpoint temperature, press and hold TEMP key
for 5 seconds (example: TEMP 340F SET 375F).
13
OPERATION
CAUTION:
HOT SURFACE
Exposed surfaces can be hot
to the touch and may cause
burns.
Oven door will be hot to the
touch during operation. Use
the provided handle to open
and close oven door.
NOTE: A "beep" will sound
each time a key is pressed.