Install Operating Systems Software - Wells M4200 Owner's Manual

PROGRAMMING INSTRUCTIONS (continued)
IMPORTANT: This oven is pre-programmed from the factory and does not require
programming adjustments under normal circumstances. Any programming
changes must be performed by qualified persons only.
PROCEDURE TO INSTALL O/S SYSTEM INTO CONTROLLER
1. Oven switch must be in the "OFF" position
2. Insert menu Runware Card into card reader slot
with chip facing down. Push in until resistance is
met, then another 1/8"
3. Press "UTILITY" and "CANCEL" button at the
same time. Hold these buttons.
4. Turn oven switch to "ON" position
5. Release "UTILITY" and "CANCEL" button
at the same time.
6. Display will read the following for
approximate time:
Rotating Bar indicates controller
is accepting information
Oven Will Start
Remove card
7. Audible alarm will sound and oven will start.
Remove card from slot and return to protective
packaging.
8. Oven will say "TOO COOL", and start to heat up.
Install operating system is now complete
ACTION DISPLAY WILL READ
LOADING O/S
TESTING CARD
LOADING O/S
LOADING DEFAULT MENU
WELLS BLOOMFIELD
INCORRECT CARD
20
APPROX. TIME
1 second
28 seconds
56 seconds
1 second
1 second
(BEEP)