Wells M4200 Owner's Manual page 26

CLEANING INSTRUCTIONS (continued)
CAUTION:
ELECTRIC SHOCK
HAZARD
Disconnect appliance from
electric power
before cleaning.
CAUTION:
BURN HAZARD
Allow appliance to
cool to 150ºF or less before
cleaning.
Do not attempt to clean the
oven until it has cooled to
150ºF or less. It can burn
you. Hand protection is
required.
CAUTION:
CUT HAZARD
Fan will be running during
cool-down. Avoid reaching
into the oven while oven is in
cool-down mode.
FAN BLADES ARE SHARP.
Use due care when cleaning
and/or wiping.
IMPORTANT:
DO NOT use steel wool
or abrasive cleansers for
cleaning this appliance.
Always wipe or rub in the
direction of the polish lines
or grain of the metal.
IMPORTANT:
DO NOT spill or pour water
into control panel or wiring.
Damage to internal
components from water
damage is not covered by
warranty.
IMPORTANT:
Take care to avoid damage to
fan blades when reinstalling
fan baffle.
PREPARATION
Allow oven to cool to 150ºF or less
FREQUENCY
Monthly
TOOLS
Fiber Brush, Plastic Scouring Pad, Plastic Scraper
Mild Detergent, McD Sanitizer,
APC All Purpose Cleaner, Clean Towel
MONTHLY CLEANING
1. With power switch ON, open oven door. Press UTILITY key.
Display will read FAST COOL MODE. Press START key. Display
will read COOL DOWN and fan will start. When oven has cooled,
press power switch OFF.
2. Remove racks and rack supports. Remove fan baffle.
3. Brush the fan wheel and wipe it with a moist cloth. Sponge out all
loose particles.
4. Scrub entire interior of convection oven with a plastic scouring pad
and APC cleaner.
5. For baked on food spills, apply APC cleaner. Close the oven door
and let stand for 10 minutes with the power OFF. Wipe food spill
with a plastic scouring pad as needed. Rinse area by wiping with a
clean sanitized towel.
6. Wipe down the entire interior using a clean cloth or moistened with
water and a mild detergent. Rinse by wiping with a clean towel
moistened with sanitizer.
7. Clean oven racks and rack supports in a sink or dishwasher.
8. Reinstall the fan baffle, paying
particular attention that the lip on
the right side of the fan baffle is
fully seated in the slot in the edge
of the oven cavity. Reinstall rack
supports and racks.
9. Press power switch ON, press
UTILITY key then START key.
Verify that fan runs smoothly and
does not contact fan baffle.
Press power switch OFF.
Reposition fan baffle if necessary.
10. Wipe down exterior of the oven
using a clean cloth moistened with
water and a mild detergent.
11. Replace oven rack supports.
PROCEDURE IS COMPLETE
24