Wells M4200 Owner's Manual page 19

IMPORTANT: This oven is pre-programmed from the factory and does not require
programming adjustments under normal circumstances. Any programming
changes must be performed by qualified persons only.
ACTION
IMPORTANT: DO NOT CHANGE FACTOR VALUES OR TIME VALUES FOR EXISTING MENU ITMES
13) Press PROG button. Display will read
14) Press PROG button repeatedly to cycle through
factor values and factor times (1 - 5).
Display will read <COOLING TIMER>
15) Press button #2 or #8 to enable or disable
cooling timer.
16) Press PROG button
17) Set desired cooling time (0 - 60 minutes)
Press button #2 to increase time
or button #8 to decrease time
18) Press PROG button. Beep will sound to
indicate new information is saved.
(This is the end of this programming
cycle. If no other menu items are to be
programmed, go on to # 19. If other menu
items are to be programmed, press PROG
to return to # 6.)
19) Press START button
20) Press START button
Programming the controller is now complete.
NOTE: ENTER PROGRAMMING and VIEW PROGRAMMING are disabled during cook cycle and while
cooling timer is activated.
PROGRAMMING INSTRUCTIONS (continued)
DISPLAY WILL READ
FACTOR 1 VALUE
FACTOR 1 TIME
COOLING TIMER
COOLING TIMER
COOLING TIME
UPDATING MENU ITEM
SELECT DAYPART
EDIT MENU ITEM
OVEN READY
17
00000
00000
NO
YES
10:00
# 1
NO