Enabling Scratch Biscuit Button (#6) - Wells M4200 Owner's Manual

PROGRAMMING INSTRUCTIONS (continued)
IMPORTANT: This oven is pre-programmed from the factory and does not require
programming adjustments under normal circumstances. Any programming
changes must be performed by qualified persons only.

ENABLING SCRATCH BISCUIT BUTTON (#6)

1. Enter programming mode, press and
hold PROG button for 5 seconds
2. Press PROG button until EDIT MENU is
reached
3. Press #2 or #8 button for YES
4. Press PROG button
See page 22 for password and recommended oven settings
5. Press PROG button to select daypart.
NOTE: Only daypart #1 is activated
6. Press PROG button
7. Press # 6 button to select SCRATCH BISCUITS
8. Press PROG button to enable any name change
9. Press PROG button
10. Press #2 button to enable SCRATCH BISCUIT
Button
11. Press PROG button
(Should always be Manual)
12. Continue pressing PROG button until beep
sounds, indicating new information was saved
13. Press START button
Enabling Scratch Biscuit button (#6) is now complete.
IMPORTANT: DO NOT CHANGE FACTOR VALUES OR FACTOR TIMES FOR EXISTING MENU
ITEMS
NOTE: Cannot go into edit or view program mode when cooling timer is activated or when in
a bake cycle.
ACTION DISPLAY WILL READ
CAL TEMP
EDIT MENU ITEM
EDIT MENU ITEM
PASSWORD
SELECT DAYPART
SEL>
SCRATCH BISCUITS
SCRATCH BISCUITS
ENABLE
ENABLE
CANCEL A/M MANUAL
UPDATING MENU ITEM
OVEN READY
18
NO
NO
YES
0000
# 1
NO
YES